• The Scanner moves to the first measuring position.
  • The spectrum analyzer is reset
  • Basic settings are transferred to the spectrum analyzer
  • The spectrum analyzer is set to max hold mode.
    (Max hold means that the highest amplitude at each frequency is kept.)
  • The spectrum analyzer takes a number of sweeps.
  • The Scanner moves to the next measuring position.
  • Steps 5 to 6 are repeated until all measuring positions are measured.
  • The frequency and amplitude of all peaks are acquired.
    (The spectrum analyzer decides what is a peak and what is not.)
  • The trace is acquired.
  • The Scanner moves to its starting position.