1. CNT-104S configuration guide
Product code (12NC): 9446 101 04XYZ
CNT-104S is configured using factory installed HW options, and customer installable options via SW license keys. The 12NC code only describes the HW configuration. SW enabled options and built-in measurement apps are coded separately, and not shown in the HW configuration 12NC code
X = RF/Microwave frequency option
0 = None
1 = Not used
2 = Reserved
3 = Reserved
4 = Reserved
5 = Reserved
6 = 3 GHz (Option 10)
7 = 10 to 24 GHz CW (Option 110, SW upgradable from 10 to 24 GHz)
8 = Reserved
9 = Customer special
Y = Oscillator option
2 = TCXO (standard oscillator in CNT-100, New)
5 = OCXO, High stability (Option 30, same as for CNT-9x)
6 = OCXO, Ultra-high stability (Option 40, same as for CNT-9x)
Z = Rear panel inputs and other HW options
1 = standard
2 = rear inputs A, B, D, E and C (Option 11/100)
3 = Reserved
4 = Reserved
5 = Reserved
6 = Reserved
9 = Customer special
2. CNT-104S configuration guide – Options and Accessories
Product code for ordered SW licenses (12NC): 9446 101 XXXYY
XXX/YY = Main option / Version. NOTE: the first “X” cannot be a 0
110 group – Prescaler frequency upgrade
110/15 = upgrade from 10 to 15 GHz CW input C SW
110/20 = upgrade from 15 to 20 GHz CW input C SW
110/24 = upgrade from 20 to 24 GHz CW input C SW
130 group – Enable HW inputs/outputs
132 = Enable Pulse output SW
150 group – Enable measurement functions
151 = Enable TIE measurements