Parameter syntax: VoltageMode
Possible values: Normal, VerySlow, Slow, Fast, VeryFast
Default value (RST condition): Normal
Description
Defines minimal signal frequency for which voltage measurements and/or auto-trigger works correctly. Please, note: voltage/auto-trigger for lower frequencies are measured at the expense of measurement speed. It is recommended to treat this setting as a fallback for the cases where Autoset fails to find best setting automatically.
VerySlow - Used for signals with frequency in range: < 10 Hz
Slow - Used for signals with frequency in range: 10 Hz to 100 Hz
Normal- Used for signals with frequency in range: 100 Hz to 1 kHz
Fast - Used for signals with frequency in range: 1 kHz to 10 kHz
VeryFast - Used for signals with frequency 10 kHz and above.
DC signals can be measured with any mode.