See page 2-16 to see how the following preprogrammed settings are recalled by a few keystrokes.
| PARAMETER | VALUE/SETTING |
| Input A & B | |
| Trigger Level | AUTO |
| Trigger Slope | POS |
| Impedance | 1 MW |
| Attenuator | 1x |
| Coupling | AC |
| Filter | OFF |
| Arming | |
| Start | OFF |
| Start Slope | POS |
| Start Arm Delay | 0 |
| Stop | OFF |
| Stop Slope | POS |
| Hold-Off | |
| Hold-Off State | OFF |
| Hold-Off Time | 200 ms |
| Time-Out | |
| Time-Out State | OFF |
| Time-Out Time | 100 ms |
| Statistics | |
| Statistics | OFF |
| No. of Samples | 100 |
| No. of Bins | 20 |
| Pacing State | OFF |
| Pacing Time | 20 ms |
| Mathematics | |
| Mathematics | OFF |
| Math Constants | K=1, L=0, M=1 |
| Limits | |
| Limit State | OFF |
| Limit Mode | RANGE |
| Lower Limit | 0 |
| Upper Limit | 0 |
| Burst | |
| Sync Delay | 400 ms |
| Start Delay | 0 |
| Meas. Time | 200 ms |
| Freq. Limit | 400 MHz |
| Miscellaneous | |
| Function | FREQA |
| Smart Frequency | AUTO |
| Smart Time Interval | OFF |
| Meas. Time | 200 ms |
| Auto Trig Low Freq | 100 Hz |
| Timebase Reference | AUTO |
| Blank Digits | 0 |
| Interpolator calibration | ON |
| Output (CNT-91(R)) | OFF |