When arming is enabled, defines whether sample block or each sample within the block should be armed.
Parameter syntax: ArmOn
Possible values: Block, Sample
Default value (RST condition): Block
Description
When arming is enabled, defines whether sample block or each sample within the block should be armed. Block of samples is a group of samples captured during a measurement (number of samples is defined by SampleCount parameter). This setting is available for modification only when arming is enabled. See StartArmingSource parameter.
Block - Arm on Block mode: entire sample block is being armed. Please note: when arming on Block and stop arming is not Off - the resulting number of samples in the block might be less than SampleCount.
Sample - Arm on Sample mode: each individual sample inside the block is being armed.
Example
SYST:CONF "ArmOn = Block"