Defines when to start internal calibration.

Parameter syntax: InternalCalibrationMode

Possible values: Every30Min, BeforeEveryMeasurement, OnceAfterWarmup

Default value (RST condition): Every30Min


Internal calibration is always done on device start-up and after it has warmed up. More frequent calibration can be done in order to improve timing measurement resolution.

Every30Min - Additional calibration every 30 minutes

BeforeEveryMeasurement - Additional calibration before every measurement

OnceAfterWarmup - No additional calibration


SYST:CONF "InternalCalibrationMode = Every30Min"