• Home
• Products
• Contact
• About

• 1. Assembling the Rackmount Kit

1. Assembling the Rackmount Kit

• Make sure the power cord is disconnected from the instrument.
• Turn the instrument upside down.
• See Figure 2-4.
• Undo the two screws (A) and remove them from the cover.
• Remove the rear feet by undoing the two screws (B).
• Remove the four decorative plugs (C) that cover the screw holes on the right and left side of the front panel.
• Grip the front panel and gently push at the rear.
• Pull the instrument out of the cover.