• There was a communication error, probably caused by an unexpected command sent to the generator. It may occur if the generator was reset and the computer program was not notified. Execute OUT->CONFIGURE CHANNELS command to cancel the error. If the problem persists reset the generator and invoke the OUT->DISCONNECT command.
  • If you always get an error then check the communications speed. You need a software communicating at 57600 baud. Older instruments require 19200 baud.
  • Do not forget to Select the baud rate in FILE->PREFERENCES.
  • If the error occurs in response to a certain function in the software you might need a firmware update. Please contact Pendulum Instruments.