ctrl–J
Couple the selected slot to a reference slot (make it a “slave” slot). Invokes a dialog where you have to choose a master from a pop-up menu and type the coupling parameters (multiplication and offset).
The width of the slave pulse will from now on follow the equation:
Tslave = n * Tmaster ± offset
The default is n = 1 and offset = 0. When a “coupled” slot is altered, the software readjusts the width of the master slot, propagates the change to all related slots, and finally transmits the appropriate information to the waveform generator (if connected and in “auto” mode).
The color of the coupled pulse changes to blue.
If decreasing the with of a coupled slot should cause that the width of another slot would be reduced to zero, it will be set to 2 time units.