1. New

Close the current design and open a new, empty one. The current design will be saved or not according to the preferences (see later on).

2. Open…

ctrl–O
Save the current design (if there is any) according to chosen preferences and open a file containing a previously saved design.

3. Import…/Export...

A text file of tabulated data (like a spreadsheet). Open exported file in text editor to see the format. The coupling information is not preserved here.

4. Save

ctrl–S
Save the current design to the disk. First time you call this command you will be prompted for the file name and location.

5. Save as…

Save the current design to the disk under another name. You will be prompted for the file name and location.

6. Print setup…

A standard setup dialog where you can choose the size of the printer paper, scale of the printout and its orientation (recommended: “landscape”).

7. Print…

ctrl–P
Print the design on the attached printer. The following information is added on the first page: file name, date, time, waveform names, groups, amplitude, type of superposition, chosen units, total number of pulses and the DC offset.

8. Preferences

Set file save preferences, disable splash screen, select communication port, baud rate and waveform generator model.

9. Quit

ctrl–Q
Quit the program. The current design will be saved or not according to the preferences (see above).