1. Start

ctrl–HOME
The waveform display will be scrolled to the ﬁrst pulse and the ﬁrst pulse will be selected.

2. Current selection

Use this menu if you have scrolled the waveform display away from the selection.

3. Marked selection

Use PULSE –> MARK SELECTION to store the current pulse range and then you can jump to it at any time by calling this menu item.

4. Restore selection…

Use PULSE –> MARK SELECTION to store the current pulse range. Choose from the hierarchical menu of stored pulse selections and jump there.

5. Pulse nr…

Go to a speciﬁed pulse number and select it. You will be prompted for the pulse number.

6. Marked pulse »

A hierarchical menu of marked pulses. Use PULSE –> MARK THIS PULSE to include a selected pulse in this menu.

7. Trigger point

Ctrl–left/right arrow to jump with trigger between marked pulses
(see menu PULSE –> MARK THIS PULSE).

Jump to a pulse containing the oscilloscope trigger point. This menu is active if there is a trigger point and only one trigger point at a time is allowed (the default setting).

8. Master pulse »

If you have coupled pulses or time-slots, you can scroll the display to a chosen reference (i.e. “master”) pulse.

9. End

ctrl–HOME
The waveform display will be scrolled to the last pulse and the last pulse will be selected.